Momentum & Newton’s Laws of Motion (CIE A Level Physics)

Three boxes A, B, and C are connected using an inextensible rope of negligible mass, as shown in Fig. 1.1.

Fig. 1.1

Boxes A and B each have a mass of 2.4 kg, and the magnitude of the frictional force  between each box and the surface is equal to 

where  is the normal reaction force and  refers to the box in question A, B or C.

Box C descends with constant velocity.

Calculate the tension in the rope connecting boxes A and B.

Determine the tension in the rope connecting boxes B and C.

Hence, determine the mass of box C.

The rope connecting A and B breaks abruptly.

A rock climber of mass 80 kg slips after attaching a bolt firmly onto a piece of rock that they are climbing as shown in Fig. 1.1. 

At the lowest point of the climber's fall, the length of the rope between the harness and the bolt is 24 m. The climber comes to rest and all the energy from the fall has been absorbed by the rope.

The rope has an unstretched length of 19 m and a stiffness of 560 N m^–1. 

Fig. 1.1

Assume that the extension of the rope is proportional to its tension and the mass of the rope and the effects of air resistance are negligible.

Calculate

Hemp is one of the strongest fibres with a very high tensile strength and is extremely rigid. Hemp ropes were the first to be used for ship rigging which adjusted the position of the sails and supported the masts. 

However, rock climbers use nylon ropes to break their fall as they can stretch considerably under tension.

A climbing equipment company tests their ropes by attaching an 80 kg mass to an end of the rope and releasing it from a ledge. 

Fig. 1.2 shows the results of a test carried out to compare the time it takes for a nylon rope and a hemp rope to return to their unstretched length after beginning to stretch.

Fig. 1.2

In the test, both ropes used had identical unstretched lengths of 19.0 m and diameters of 10 mm.

Show that the average resultant force exerted by the hemp rope is about 20 times larger than the average resultant force exerted by the nylon rope.

Discuss in terms of force and momentum, why nylon ropes are favoured by rock climbers compared to hemp ropes.

A baseball is raised from the ground and dropped onto a hard plate to test its properties. A sensor measures the force exerted by the plate on the ball during its collision with the plate. 

The variation of force exerted on the baseball with time is shown on the graph in Fig. 1.1. 

Fig. 1.1

The ball of mass 150 g strikes the plate with a speed of 22.5 m s⁻¹. It leaves the plate with a speed of 12.8 m s⁻¹.

Show that this is consistent with the impulse obtained from the graph.

Considering the first 73 ms of the ball's motion:

The ball continues to bounce, each time losing the same fraction of its energy when it strikes the plate. Air resistance is negligible. 

Determine the percentage of the original gravitational potential energy of the ball that remains when it reaches its maximum height after bouncing five times. 

Explain, with reference to the conservation of momentum, the effect that the motion of the squash ball has on the motion of the Earth from the instant it is released until it bounces off the plate.

A stationary uranium nucleus decays by emitting an α particle and thorium nucleus. 

Discuss how the principle of conservation of momentum applies in this explosion. 

Assume that all of the energy released in the emission process is transferred as kinetic energy to the α particle and the recoiling nucleus and is equal to 6.55 MeV.

Calculate the kinetic energy of the Thorium nucleus and α particle in MeV. 

Show that momentum is conserved in this decay.

Collisions can occur between neutrons and stationary Uranium nuclei, for example, during nuclear fission.

Discuss how this collision would be if this was inelastic as opposed to elastic.

Newton’s third law refers to pairs of forces.

For a pair of forces that obey Newton's third law, describe:

Two blocks A and B are joined by a string and rest on a frictionless horizontal table as shown in Fig. 1.1. A force of 200 N is applied horizontally on block B.

Fig. 1.1

Block A has a mass of 3.0 kg and block B has a mass of 7.0 kg. 

The string is removed from the blocks. Block A slides along the horizontal frictionless surface towards block B, which is stationary, as illustrated in Fig. 1.2.

There are no resistive forces acting on block A as it moves towards block B. At time t = 0, block A has a velocity of 0.20 m s⁻¹. A short time later, the blocks collide and then separate.

The variation with time t of the momentum of block B is shown in Fig. 1.3.

Use Fig. 1.3 to describe, without calculation, the magnitude of the acceleration of block B from:

Use Fig. 1.3 to determine

A cyclist carries out tests on the braking system of their bicycle.

At time t = 0 the cyclist is travelling at an initial speed of u as they apply the brakes and come to a stop at time t = 2.0 s.

Fig. 1.1 shows the variation of the braking force F on the bicycle with time t.

Use Newton’s second law of motion to explain the physical quantity represented by the area under the graph shown in Fig. 1.1.

The total mass of the cyclist and bicycle is 82 kg. 
Use Fig. 1.1 to calculate the initial speed u.

Complete Fig. 1.2 to show the variation of the speed of the bicycle from t = 0 to t = 2.0 s.

Fig. 1.2

Brakes testing is a crucial part of the manufacturing process of any vehicle.

A train manufacturer wants to determine the effect of a rapid deceleration on passengers riding their new model of train.

Four crash test dummies are placed on different seats on the train as shown in Fig. 1.3. During the test, the train travels at a high speed in the direction shown and after a time, the brakes are applied. Seat belts are not used on trains.

With reference to at least one of Newton’s laws of motion, discuss which seat, A−D, is the safest for a passenger to be sitting on in the event of a rapid deceleration.

You may assume that the seats all remain fixed firmly to the floor and do not break.