Investigating Force & Extension (CIE IGCSE Physics)
Revision Note
Author
LeanderExpertise
Physics
Investigating Springs
- When forces are applied to materials, the size and shape of the material can change
- The method below describes a typical procedure for carrying out an investigation into the properties of a material
An experiment to measure the extension of a spring
- Set up the apparatus as shown in the diagram
- A single mass (0.1 kg, 100g) is attached to the spring, with a pointer attached to the bottom, and the position of the spring is measured against the ruler
- The mass (in kg) and position (in cm) are recorded in a table
- A further mass is added and the new position measured
- The above process continues until a total of 7 masses have been added
- The masses are then removed and the entire process repeated again, until it has been carried out a total of three times, and averages can then be taken
- Once measurements have been taken:
- The force on the spring can be found by multiplying the mass on the spring (in kg) by 9.81 N/kg (the gravitational field strength)
- The extension of the spring can be found by subtracting the original position of the spring from each of the subsequent positions
- Finally, a graph of force (on the y-axis) against extension (on the x-axis) should be plotted
A graph of force against extension for a metal spring
You've read 0 of your 0 free revision notes
Get unlimited access
to absolutely everything:
- Downloadable PDFs
- Unlimited Revision Notes
- Topic Questions
- Past Papers
- Model Answers
- Videos (Maths and Science)
Did this page help you?